 Punch Pins ™
Fasten to Sheet Metal... without drilling
|
See How It Works 
Click Here To View Movie
|
 Now you can fasten light loads to sheet metal in less time than it takes to drill a hole. This simple, quick fastener is
perfect for attaching nameplates, wiring clips and small components to metal doors, electrical cabinets, steel tubing, etc.
Simple application.
Position the Punch-Pin on the tip of the tool, push the tool against the base metal and pull the trigger.
The Punch-Pin is driven in a single impact. The fastening is fast and permanent.
No surface preparation.
The hardened steel fastener drives through dirt, oil, grease and most paints. Specially shaped,
annular grooves bite into the softer base metal and form a permanent attachment which holds up to 250 pounds. No cleaning,
no drilling.
No alignment problems.
A Punch Pin makes its own hole in the base metal so there is never a problem aligning attachment
holes with base metal holes. |
Ordering Information
| Part Numbers:
|
Punch-Pin #6140
|
|
|
Air Hammer #221
|
|
|
Magnetic Driver #226
|
| Packaging:
|
1,000 Punch-Pins per vial.
|
| Shipping:
|
UPS ground unless otherwise specified.
|
| Please call Amtak customer service with any questions.
|
|
